AR# 12386


4.1i BitGen - DRC Warning: "Designrules:331 - Blockcheck: Dangling XUSED output..."


Keywords: BitGen, Designrules, DRC, blockcheck

Urgency: Standard

General Description:
BitGen issues a DRC Warning similar to the following:

WARNING:DesignRules:331 - Blockcheck: Dangling XUSED output. XUSED of comp UCORE/RBSAA/rb_gcr_map/bcsd_irq_src_sync(17) is configured, but output is not used.


This warning can be safely ignored in most cases. To be certain, check your design in FPGA Editor using the steps below. The warning message is typically issued because of an unusual, yet valid slice configuration.

To check this warning message:

1. Open the design in FPGA Editor.
2. Navigate to the offending slice. (The components are listed alphabetically in the component list on the right side of your screen in FPGA Editor.)
3. Double-click on the slice mentioned in the warning message. (For example, in the warning above, the slice would be UCORE/RBSAA/rb_gcr_map/bcsd_irq_src_sync(17).)

The warning may be ignored if the following criteria are met:

1. The F5 and X outputs are both in use.
2. The same signal name is shown on both of these outputs.

This configuration is not common, although it is perfectly legal. The XUSED component is the mux that drives the .X output from a slice.

If the above criteria are not met, please contact Xilinx Technical Support for assistance by opening a WebCase at:
AR# 12386
日付 09/30/2005
ステータス アーカイブ
種類 ??????
People Also Viewed