AR# 1319


M1: EDIF2NGD doesn't recognize the parttype from a Viewlogic EDIF file.


If you add the parttype in a Viewlogic schematic as an
unattached attribute and generate an EDIF file with
EDIFNETO, EDIF2NGD will not recognize the parttype.


To work around this problem, put a config symbol on
the top level sheet and attach the part=<parttype>
attribute to this symbol. This will cause the
attribute to be written into EDIF file in a way that
EDIF2NGD can recognize it.
AR# 1319
日付 12/07/2004
ステータス アーカイブ
種類 一般
People Also Viewed