We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 17731

LogiCORE SPI-4.2 (POS-PHY L4) v6.0 - "PAR ERROR:Place:44 - The global clocks pl4_src_top0/..." occurs when I target an XC2VP70-FF1704


General Description: 

The following error occurs when I run place and route (PAR) on a design with an SPI-4.2i core targeting an XC2VP70-FF1704 device. 


"ERROR:Place:44 - The global clocks pl4_src_top0/pl4_src_clk0/DCM_highspeed.tdclk180_bufg0 (BUFGMUX5S) and pl4_snk_top0/pl4_snk_clk0/LowFreq.StaticAlign_StaticAlign.snkclk_bufg0 (BUFGMUX5P) are locked into a primary/secondary site pair. It is impossible to route all of the clock loads for both of these clocks using the global clock routing resource. Only one of primary/secondary pair clocks have access to any one quadrant via global (high drive/low delay/low skew) routing resources. If these two clocks drive clock inputs in the same quadrant the nets will not be routable using the global clock routing resources." 


This results in the design failing timing.


If you encounter this issue, please open a WebCase at: 


AR# 17731
日付 05/15/2014
ステータス アーカイブ
種類 一般