UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 2720

9.1i PAR - "ERROR:baspl:291,292 - pull-up could not be placed"

説明

PAR reports the following warnings and errors for my design:

"WARNING:baspl:291 - The PULLUP component "<instance_name>" could not be placed.

ERROR:baspl:292 - This is probably due either to lack of resources or to preference conflicts."

ソリューション

This error can occur if the PULLUP component is used improperly. Pull-ups should be used only on Input Pads, Open-Drain outputs, and 3-State Outputs. Pull-ups cannot be used to drive a logic 1 on other types of signals. To drive a logic 1 on other signals, use the VCC symbol. For more details about these and other components, please see the Libraries Guide at:

http://toolbox.xilinx.com/docsan/xilinx10/books/manuals.pdf

AR# 2720
作成日 08/21/2007
最終更新日 05/08/2014
ステータス アーカイブ
タイプ 一般