AR# 30106

|

Spartan-3A/-3AN/-3A DSP - BSDL design warnings might not be in the .bsd file

説明

There are no DESIGN_WARNINGS listed in the BSDL file for the Spartan-3A device.

ソリューション

The following design warnings will be added to all of the Spartan-3A devices in the next release of the software.

attribute DESIGN_WARNING of device : entity is

"This is a preliminary BSDL file which has not been verified." &

"This BSDL file must be modified by the FPGA designer in order to" &

"reflect post-configuration behavior (if any)." &

"To avoid losing the current configuration, the boundary scan" &

"test vectors should keep the PROG_B pin" &

"high. If the PROG_B pin goes low by any means," &

"the configuration will be cleared." &

"PROG_B can only be captured, not updated." &

"The value at the pin is always used by the device." &

"HSWAP_EN, M0, M1, and M2 can only be captured, not updated." &

"The value at the pin is always used by the device." &

"The disable result of a 3-stated I/O in this file" &

"correspond to HSWAP_EN being high. When HSWAP_EN" &

"is low, change all PULL0s to PULL1." &

"In EXTEST, output and tristate values are not captured in the" &

"Capture-DR state - those register cells are unchanged." &

"In INTEST, the pin input values are not captured in the" &

"Capture-DR state - those register cells are unchanged." &

"The output and tristate capture values are not valid until after" &

"the device is configured." &

"The tristate control value is not captured properly when" &

"GTS is activated.";

AR# 30106
日付 12/15/2012
ステータス アクティブ
種類 一般
People Also Viewed