UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 3030

Foundation XVHDL, XC9500: How to set an output to high impedance (Hi-Z)

説明

Keywords: high, z, impedance, xvhdl, foundation,
9500, unused, tie

Urgency: Standard

General Description:

Sometimes it is necessary to tie unused pins to
high impedance. This may be the case if changes
were made to the logic of a device but the pin is
on a bus externally. Tieing the pin to gnd or vcc
may have drastic effects on the bus.

ソリューション

To tie an unused pin to High-Z in Foundation XVHDL, change the
pin to an output std_logic vector, and declare a signal as follows:
signal: bit :='0';

Outside of a process use the following equation:

outz <= 'Z' when controlz = '0' else '0';


Example:

library IEEE;
use IEEE.std_logic_1164.all;

entity hiz is
port( a:in bit;
b:in bit;
clk:in bit;
d:out bit;
oz:out std_logic
);
end hiz;

architecture rewrite of hiz is
signal controlz:bit:='0';
begin

process(clk)
if clk'event and clk='1' then
d<=a and b;
end if;
end process;

oz<='Z' when controlz='0' else '0';

--oz will always be 'Z' since controlz is tied to gnd
--and never used.

end rewrite;

-------------------------------
This will implement the following equations as seen in the
fitting report

/oz = Vcc
oz.TRST = Gnd

AR# 3030
作成日 11/03/1997
最終更新日 06/03/1999
ステータス アーカイブ
タイプ 一般