This Answer Record contains the Release Notes for the LogiCORE CPRI v2.2 Core, released in the ISE 11.2, and includes the following:
- New Features
- Bug Fixes
- Known Issues
For installation instructions, general CORE Generator known issues, and design tools requirements, see the IP Release Notes Guide at:
http://www.xilinx.com/support/documentation/ip_documentation/xtp025.pdf
New Features
- ISE 11.2 support added
- Virtex-6 support added
Resolved Issues
(Xilinx Answer 32517) LogiCORE CPRI v2.1 - When using Virtex-5 FXT, the second GTX value for attribute PMA_CDR_SCAN is not optimal
(Xilinx Answer 32645) LogiCORE CPRI v2.1 - Virtex-5 FXT - Missing constraint in Example Design UCF
- IR 519309: Master core CDC FIFO does not infer block RAM in Virtex-6.
- IR 490086: Possibility of first RX Strobe arriving earlier than expected.
- IR 473738: Slave toggles TX inhibit at startup.
Known Issues
- Virtex-6 solutions are pending hardware validation.
-Software Support for the Virtex-6 Lower Power parts was added in this release, but the CPRI core does not yet support these devices and cannot be generated from CORE Generator targeting Virtex-6 Lower Power. Pending further testing support for Virtex-6 Lower Power parts is planned for 11.3. In order to work around this issue, you can set your project to target an equivalent Virtex-6 LXT device which will allow you to generate the IP.
Answer Number | アンサータイトル | 問題の発生したバージョン | 修正バージョン |
---|---|---|---|
36969 | LogiCORE IP CPRI - リリース ノートおよび既知の問題 | N/A | N/A |
AR# 32757 | |
---|---|
日付 | 05/23/2014 |
ステータス | アーカイブ |
種類 | 一般 |