We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 3294

M1 JTAGPGMR: Basic debugging techniques for downloading design


Keywords: 9500, CPLD, jtagpgmr, chain, downloading

Urgency: Standard

General Description: When having errors while trying to
download a design to a 9500, try the following steps to debug
the problem. This solution is for using the M1 JTAG
Programmer, if you are using the EZTAG software released with
Xact 6.x tools, refer to (Xilinx Solution 2939).



Check that the JTAG download cable is attached directly to
the parallel port on the PC. Make sure there are no hardware
keys between the PC and the cable.


If you are using the JTAG cable (model DLC5) make sure there
is less than five devices in the chain, and only four devices
in the chain if you are using the XCHECKER cable. If you are
using more than the recommended number of devices you will need
to buffer the four JTAG signals.

Also see (Xilinx Solution 1272)


If you are using the JTAG cable, make sure the serial number
is above 5000. There are some known issues with parallel ports
and devices with numbers below 5000.

Also see (Xilinx Solution 1605)


Check that there are decoupling CAPS attached to each VCCINT
and VCCIO pin, to nearest GND. Recommended capacitor values
are 0.1uF and 0.01uF.


Check the supply voltage to the POD of the cable. Make sure
that VCC is 5v and the GND is connected to a common ground with
the device that is being programmed.


Check for noise on the board. The TCK pin is very sensitive
and can cause problems when trying to configure. Try putting a
small capacitor between TCK and GND.

Also, disable all free running clocks, if possible. Fast
clocks may introduce "extra" signals on to an otherwise quiet


If you are using the XChecker cable (Model DLC4), make sure you
have the RD pin on the cable connected to the TDO pin of the
AR# 3294
作成日 08/31/2007
最終更新日 09/30/2005
ステータス アーカイブ
タイプ ??????