We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 3427

M1.4 MAP: ERROR:x52ma:250 This type of signal is not supported by the XC5200 ...


Keywords: primitive, FDP, FTP, FDPE, asynchronous

Status: Standard

General Description:

ERROR:x52ma:250 - FDP symbol "INSTANCE" (output signal="Net")
has an asynchronous set pin. This type of signal is not
supported by the XC5200 architecture.

Ngdbuild is finding a FDP with a proper set of pins in the
base library definitions and is using it (which is a primitive). The XC5200 does not have an asynchronous set as
a primitve.

Note that this will only be a problem for hierarchical netlist flows such as XNF, since the macro instantiation and its definition are in separate files. In a typical EDIF flow, the macro will be defined in the EDIF, and NGDBUILD only expands leafs in the hierarchy. However, some EDIF writers such as ORCAD generate hierarchical EDIF netlists which result in the error.

This error may also apply to other symbols from the XC5200


In the case of an FDP:

Implement the FDP using some other (non-Xilinx name), MYFDP
for example. In order to get an FDP one has to first use the
FDPE. To implement an FDPE invert the D-input and the Q-output of the FDCE (a primitive). To implement an FDP from
FDPE, just tie the clock enable to Vcc. This symbol has the functionality of a flip flop with an asynchronous preset

Similarily one can implement the FTP or any other symbol
that may have caused this problem.
AR# 3427
日付 04/19/2000
ステータス アーカイブ
タイプ 一般