AR# 3955


F1.4, Simulator: Probes from schematic macro don't appear in Simulator.


Keywords: Schematic, macro, simulate, current, probes

Urgency: Standard.

General Desciption:
After placing probes on a lower-level schematic-based macro, and then selecting "Simulate Current Macro" these probes do not appear in the simulator.


This is a bug with the "Simulate Single Component" command. To workaround it, simply add the signals in the waveform viewer with the 'Add Signals' command (Signal -> Add Signals).
AR# 3955
日付 04/04/2000
ステータス アーカイブ
種類 一般
People Also Viewed