We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 1909

Orcad Simulate - How do I use Xilinx's global reset and 3-state signals for functional simulation?


Keywords: Simulate, global reset, 3-state, tri-state, signal, functional simulation

Urgency: Standard

General Description:
How do I use Xilinx's global reset and 3-state signals for functional simulation?


Xilinx has global signals that are used to set and reset flip-flops and initialize 3-state buffers.
These signals are as follows:

GR - Global Reset for Xilinx 2K, 3K, and 5K families.
GSR - Global Set/Reset for Xilinx 4K and 4K-E families.
GTS - Global 3-state for Xilinx 4K, 4K-E, and 5K families.

These global signals will not be in the VHDL netlist created by Capture. Therefore, in order to
simulate them functionally, you will need the latest Xilinx model files that are on the Orcad web
site at:


The name of the file is "XLIB.ZIP," and it is password-protected. If you are interested in getting
the updated model files, please e-mail Orcad at techsupport@orcad.com, so they can give you
the password.

There are two model files for each Xilinx family. One file contains the primitives for a particular
Xilinx family and the other file, which has an _M in the name, contains the macros for a particular
Xilinx family. Place any set of these files in your project as VHDL model files, and then load your
project normally. When you create a stimulus for the design, you will notice a new context
underneath your design context. This new context is where you can stimulate the global signals
before you run a simulation.
AR# 1909
日付 10/01/2008
ステータス アーカイブ
種類 一般