We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!


AR# 54196

What is the meaning of the fast and slow corner columns in Speedprint?


What is the meaning of the fast and slow corner columns in Speedprint?


Alwaysrefer tothe trce timing results for timing analysis completion.

The followingapplies to ISE14.x Speedprint, whichincludes Multi-CornerTimingAnalysis.
  • Speedprint output describes the data columns and the conditions under which more than one min/max are output.
For each timing delay name, Speedprint will report minimum and maximum values for both fast silicon and slow silicon.If all paths for a given delay name have the same value, then the output will look like:
Timing Delay Name (fmin/fmax) (smin/smax)
A single timing delay name may be used for different paths, and can have different values. In the case where a timing delay name has more than one set of values, speedprint will report two sets of max and min values representing the slowest path information and the fastest path information, as such:
Timing Delay Name (fmin/fmax, fmin/fmax) (smin/smax, smin/smax)
fmin: minimum delay for fast silicon
fmax: maximum delay for fast silicon
smin: minimum delay for slow silicon
smax: maximum delay for slow silicon
For additional information: (Xilinx Answer 35963)
AR# 54196
日付 02/08/2013
ステータス アクティブ
種類 一般
  • Virtex-6
  • ISE