We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!


AR# 8289

Virtex Configuration - Device will not start configuration


My Virtex device will not start the configuration process.


Before any data is loaded into the device, a sync word (0xAA995566) must be loaded. If it is not loaded properly, all data will be ignored. If the configuration is being done via the SelectMAP interface, make sure that D0 is the MSB of the data word. If the data is loaded backwards, it will not be synchronized.

If the mode pins are set incorrectly, the device may not configure. For instance, if the intention

is to configure in Master Serial and the mode pins are accidently set to Slave Serial, the device

will be expecting a clock, but none will come.

If there are no other loads on the mode pins, the internal pull-ups will pull them to a logic level

one. If they require pull-downs, make sure the voltage level is low enough at the pin.

The PROG pin must be released (and the INIT line after it) before the device the configuration

process. If there is an external load pulling either PROG or INIT low, the device cannot be configured

in either serial mode or SelectMAP mode. If INIT is pulled low only, the device may be configured via

JTAG. But if PROG is pulled low, the device cannot be configured in any mode.

AR# 8289
日付 12/15/2012
ステータス アクティブ
種類 一般